AGPtek LS01 Bedienungsanleitung Seite 4

How to use DIY buttons?
1. Press button to turn it on,
choose from the 6 DIY buttons(eg.
DIY1), press the button DIY1 to start.
2. To DIY the color, adjust the RGB
color you want with buttons in
"DIY the color you prefer"section.
(please do not press any button
during the setting, or it will exit DIY settings)
3. Press the DIY1 button again to save the color you
set previously.
Note: You can set 6 different DIY settings with the 6
DIY buttons by the above steps.
To go to the DIY settings you set previously(eg. DIY1),
simply press the DIY1 button after you turn on the
controller.
Installation Guidelines
1. For DC 12V power output only.
2. Always turn power off at breaker before making
connections.
3. Before making any modifications (cuts), connect
uncut length of Strip Tape to controller & power to
check functions.