Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation and connection
Installation and connection
Scope of delivery
The scope of delivery contains a 3-pole and
6-pole Molex plug with connector pins, an
IR receiver with 4-pole Molex plug, an IR re-
mote control and two 1.5-V batteries for the
remote control.
Notes about the installation
Note the following when selecting a place
for installation:
•
Under the surface on which the device
is to be installed, there may not be any
wires or tubing.
Do not install the device in a place,
•
where it is subject to direct sunlight,
•
near hot air outlets (heating, etc.),
•
where it is subject to rain or moisture,
•
where it is subject to dust or dirt,
•
where it is subject to strong vibrations.
16
General connections
Power supply
Create a cable for the power supply of the
TV tuner.
Feed a cable from Pin3 (ON) to the VIDEO
RELAY socket at your CCA or CPA (switched
power supply of the video monitors).
Connect Pin2 with an earth wire and Pin1
with a +12-V or +24-V line.
3
Pin1: Continuous positive 12 V/ 24 V,
Pin2: Earth
Pin3: ON/OFF (+12 V/+24 V = ON,
0V = OFF)
Connect the connector plug into the 3-pole
12/24 VDC socket B at the side of the
tuner.
Note:
If the tuner is operated as stand-alone,
Pin3 may not be connected (open =
ON).
IR remote control
The infrared receiver of the remote control
can be connected to the 4-pole IR-REMOTE
socket D and installed anywhere in the
vehicle.
Antenna connection
Connect the cable of your TV antenna to the
antenna socket G at the TV tuner.
2
1
Werbung
Kapitel
Inhaltsverzeichnis
