Connection Guidelines - Perel E300LS Bedienungsanleitung

3. General Guidelines
 Refer to the Velleman
pages of this manual.
 Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
4. Installation and Connection
Installation Guidelines
 Install the detector at a distance of minimum 60 cm when using a
lamp of 60 W or more.
 Do not install the detector directly below a light source.
Installation
Install this detector flat on a wall or in a corner. Use an appropriate
screwdriver and the included screws and nylon plugs.
1. Open the device by turning the upper cover.
2. Connect the detector (see below) and fix the bottom.
3. Re-install the upper cover to close the detector.

Connection Guidelines

Risk of electroshock! Touching live wires can cause life-threatening
electroshocks.
1. Have the device installed by qualified personnel.
2. Disconnect the power source.
3. Cover and shield any adjacent live components.
4. Ensure the device cannot be switched on.
5. Make sure the power supply is disconnected.
See illustration on page 3.
1 power supply
V. 02 – 06/11/2018
E300LS
® Service and Quality Warranty on the last
4
2 load
©Velleman nv