Contact Information - LAS 10640 Bedienungsanleitung

The arrow must point to the green (OK) area of the marking (position 4 in the overview), Fig. 3. If the arrow is outside the green area, check
that the coupling claw is firmly seated, if necessary repeat the coupling procedure. If the coupling dog or the ball is worn out too much, the
arrow is also outside the green area. Replace worn parts.
5.4 Decoupling
Actuate the safety lever (position 3 in the overview) and simultaneously pull the handle (position 1 in the overview) upwards. Lift the coupling
claw off the trailer coupling.
5.5 Theft protection
The locked coupling claw can be secured against theft by inserting a plug lock (LAS article number 10650) into the handle.
5.6 General note
"The mechanical coupling device shall be fitted to the vehicle in accordance with the requirements of Annex VII to Directive R55-
01"
"Reference is made to the requirements of § 13 FZV (German Vehicle Registration Ordinance) with regard to the data in the
registration certificate relating to the permissible trailer load (no.: O.1 and O.2) and to the permissible drawbar load (no.: 13)"
6. Maintenance and service
All moving parts of the coupling dog must always be lightly oiled to ensure proper function.
7. Notes on environmental protection
At the end of its service life, dispose of the coupling dog via the recycling bin or the public/municipal collection points. The materials are
recyclable. Through recycling, material recycling or other forms of reuse of old equipment, you make an important contribution to protecting
our environment!

8. Contact information

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com