Werbung
For connecting or activating the system the standard applied table switch can be
used.
When the system must be connected or activated with an external controll
system, use the below listed option:
-use a separate potential free relay or switch with neutral middle position for
each direction
-always use potential free contact closures (dry contacts)
-switching time delay of at least 0.5 seconds for up and down direction.
For use with an external controll system the standard cable can be modified by
cutting of the switch and use below listed / attached colour scheme to activate
the system.
Second option is to use a new control cable with an RJ45 connector.
NOTE:
When the system is used in combination with an external limit switch (P5627),
route the green (up) wire through the end switch.
Pos. 8 red (down)
Pos. 5 green (up)
Pos. 4 blue (common)
2011-05
© Audipack
Werbung
