Holux M-1000B Kurzanleitung Seite 2

Instructions for First Use
1. Installing the Battery
2. Charge the Battery
3. Switch on the Power
4. Bluetooth Link
Note about Bluetooth connection
When you power on the
self-test before a connection is established. Wait until the Bluetooth light starts to flash (at 3
seconds interval). Then a Bluetooth link can be established between a PDA and the
M-1000B
.
sing the supplied rechargeable lithium-ion
U
battery, install it as shown in the adjacent diagram,
and replace casing.
To ensure safe operation, only use battery as
instructed.
Connect the supplied power cord to the mini USB
socket, and attach to car cigarette lighter.
You can also use common USB-Mini USB cable to
charge by link
cable is for battery charging only, which can not
provide any data transmission function.
Always ensure that you have inserted the end of the
power cord into the correct socket when connecting
the mini USB connector.
Slide the power switch to the ON position.
To operate link with a PDA (Personal Digital
Assistant): Setup the Bluetooth Manager, select
Search, and link.
Select the HOLUX_
SPP slave to establish the Bluetooth link.
Refer to the "Software Installation" section for details if
you have any problem installing the Bluetooth link.
M-1000B
, you need to wait 6 seconds for Bluetooth to conduct
M-1000B
to laptop. This common USB
M-1000B
device and choose