Bedienungsanleitung
Artikel Nr.: 846006
7. LED Controller
LED Controller - mounting instructions
To derive the heat, we recommend the installation to allow sufficient space for the air to circulate and the driver will not be overheated. Make
sure that all connections are tight. The signal line should be as far away from the power line (230V).
8. LED Instructions for mounting and safety
a.
We recommend installing the stripe in an aluminum profile.
b.
The stripe must not be connected to the supply voltage when it is in the package or rolled up on a reel.
c.
Do not use the stripe when it is covered or set in a surface.
Exception: aluminum profiles provided for this purpose.
d.
The product is not compatible with the products of another manufacturer.
e.
For connection use suitable connectors.
Open ends must be tightly closed before use.
f.
Outside the marked signs do not open or slit the stripe, please refer enclosed data sheet „Cutting possibility".
g.
Not suitable for covering with thermal insulation material.
7
12.06.2017