Safety Instructions; Battery Installation; Troubleshooting - TACKLIFE MDA01 Bedienungsanleitung

Safety Instructions

1. Reading the instruction sheet carefully before using the measuring tool;
2. This is a sensitive precision tool. Do not disassemble it by yourselves or drop it;
3. Please be careful of the sharp edge, avoid scratching;
4. Store the measuring tool at the place where the children could not reach;
5. Do not use the measuring tool as a toy to play or as a weapon to hit people;
6. Clean the measuring tool with a bar of mild liquid soap and a damp cloth, after
it, clean it with the dry and soft cloth, never immerse in water.
7. If the measuring tool will not be used for a long time, store it to a dry and shady
place. Never leave it outside at a wet and shiny environment. Before storing a
wipe with anti-rust oil is recommended;

Battery Installation

To replace battery, push the protrudent on
the bottom of the LCD. The edge of the
battery container is shown on the upperside
of the LCD.
Operating Instruction
Short press ON/OFF to turn on the measuring tool. Short press ON/OFF
to shut off the LCD.
ON/OFF button
Long press ON/OFF for more than 3 seconds to shut off the whole system.
Automatically shut off function in 6 min.
Move the scale to turn on the device when at the status of off LCD.
ZERO button
Press ZERO to set zero at any points when turn on the measuring tool.
Rotate clockwise to tighten the moving ruler;
Rotate counter ckockwise to loosen the moving
ruler.
Tighten
Trouble Shooting
Problem
No display or ambiguous
Erratic display
Number skip or frozen display
Pull the battery container out.
Button Function
Put the tool on any surface and short press ZERO
to set zero
Short press ON/OFF to turn it on, put it on the flat
surface as protrudent on, make sure both ruler's
edges touch the surface, press ZERO to set zero
Possible Cause
Lower voltage,no batteries or
incorrect installation of batteries
Casual misfunction caused by
high vibration or strength
Swinging
Internal error
EN
Technical Specifications
Accuracy
Resolution
Working Range
Power Supply
Working Current
Working temperature
Working Humidity
The negative pole of battery is upside,
positive pole is downside.
Zero setting Remove battery
0.3°
0.1°
000.0°~999.9°
CR2032 3V Lithium Battery
≤100μA
32°F to 122°F (0°C to 50°C)
≤85%
Push the battery container back.
ON/OFF button
ZERO button
Rotate the ruler to
measure the angle
Rotate the ruler to
measure the angle
Solution
Reinstall batteries
or replace batteries
and wait for a while
1 minute and replace