Unpacking The Device; Location Of Controls; Charging The Device - LEXIBOOK BTHP410series Bedienungsanleitung

UNPACKING THE DEVICE

When unpacking, ensure that the following elements are included:
1 x Bluetooth® Stereo Headphones / 1 x Micro USB charging cable / 1 x
3.5mm audio cable / 1 x Instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties
and tags are not part of this product and should be discarded.

LOCATION OF CONTROLS

Refer to the diagram p.2:
1. Power/call/play/pause button
2. Volume up/next button
3. Volume down/previous button
4. LED indicator
5. Microphone
6. Micro USB port
7. Aux-in jack
TURNING THE DEVICE ON AND OFF
1. To turn the Bluetooth® headphones on, press and hold the power button
(1). A signal tone is emitted and the LED (4) will start blinking red and blue.
2. To turn off the device press and hold the same button until you hear "Power
off".
Note: After approximately 5 minutes of inactivity, the Bluetooth® headphones
powers off automatically.
WARNING: Significant electromagnetic interference or electrostatic
discharges may cause the device to malfunction or lose data. If the device is
not functioning correctly, switch it off and then on again, or unplug the USB
cable.

CHARGING THE DEVICE

The Bluetooth® headphones operates with the micro USB charging cable
(included) or with a USB type adaptor (not included) 5V.
Power supply
1. Make sure to power off the headphones before charging it.
2. Insert the small end of the micro USB cable (included) into the micro USB
charging port (6).
3. Connect the other end of the micro USB cable into the USB port of your
powered computer or USB type power adaptor and plug it into a wall socket.
The LED lights up in red when the headphones are charging.
4. The LED indicator turns off when charging is complete.
Note: Please note that the micro USB cable can be used for battery charging
only and not for data transfer.
The micro USB cable can be used for charging during playback.
WARNING:
• Risk of explosion if battery is incorrectly replaced. Please only replace it with
an identical or an equivalent battery. (For Service instructions only; battery is
not intended to be replaced by the USER).
• The battery should not be exposed to high temperatures, such as sunlight,
fire or anything similar.
8
BTHP410seriesIM1117_V11_217YL.indb 8 16/3/17 3:33 pm