Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
INSTALLATION AND CONNECTIONS
1) Attach the LED curtain via its Velcro loops, e.g. to a truss element. A suitable stand system "Show Stand
I" by EUROLITE is available as accessory. Smoothen the curtain fabric and take care not to bend the
inner cables. Do not step on the curtain to avoid damaging the installed LEDs and electronics.
2) Plug the LED curtain's 3-pin connection cable SIGNAL IN into one of the jacks PORT 1 to 4 on the
controller. Lock the connector with the retaining ring. This way, up to four LED curtains may be
connected to the controller. If necessary, use the extension cable included in the delivery.
3) Plug the LED curtain's 2-pin power cable DC IN into the jack POWER IN on the power supply unit.
Again, lock the connector with the retaining ring. First, connect the power unit supply unit to the mains
and then the controller. Both units are designed for 100-240V~, 50/60 Hz. You can now play one of the
programs on the included SD card, create your own programs with the software LPlayer or operate the
controller with a DMX lighting console.
Important Notes
1) The LED curtain must be installed in a professional and safe manner. Never block any escape routes
with the LED curtain!
2) Do not to bend the inner cables of the LED curtains when disassembling and packing.
3) Do not step on the curtain to avoid damaging the installed LEDs and electronics.
4) Carefully fold the LED curtain and place it in the designated transport bag.
5) During transportation and storage, do not place heavy objects on the transport bag.
6) For installation in public or industrial areas, a series of safety instructions have to be followed. The
operator must inform himself on the current safety instructions and consider them. The manufacturer
cannot be made liable for damages caused by incorrect installations or insufficient safety precautions!
www.eurolite.de
26
Werbung
Inhaltsverzeichnis
