Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Notes for removing faults
Fault
Remote control does
not work.
If the fault can not be remedied using the above listed remedies, then the plug has to be removed from
the socket. A specialist must now establish the cause and carry out the repair work accordingly.
If the mains cable to this unit is damaged, then it can only be repaired by a repair workshop named by
the manufacturer, due a special tool being needed.
Note: Opening the unit and repairs may only be carried out by a specialist!
Caution!
Before starting the installation it is essential to
switch off the mains voltage on all poles! Protect
against accidental switching on by third parties!
Inserting the battery into transmitter
B
attery Type:
9V / 6F22
Positioning and mounting the receiver of the FB-FNK 3600 remote control
C
aution
Place the receiver between the power supply and the heater and fasten it as shown below. Make
sure that no one can stumble over the power cord!
Ø 6 mm
12
Reason
Receiver is switched off.
Mains plug not correctly inserted. Insert mains plug.
House fuse blown/trip defective
Remote control handpiece and
receiver are not paired.
100 mm
25%
50%
75%
100%
ON/OFF
Coding Power
Remedy
Switch on receiving unit.
Check house fuse/trip.
Repeat pairing of remote control handpiece
and receiver according instruction manual.
4 x
Werbung
