Application / Fields Of Operation - HEYLO PLUS Bedienungsanleitung

(4) Application / fields of operation

The main purpose of Dust Stop PLUS is the use in case of dust-intensive work at varying work
locations. The combination serves the industrial safety and health protection, safeguards the
remediation target and increases the efficiency of the work. By air filtration, harmless ambient air is
ensured. This is used for the protection of the employee, and at the same time increases the work
performance. Unaffected areas and residents are protected against detrimental particles from
spreading. By sealing off and by generating negative pressure in the refurbishment area, the success
of micro-cleaning in the removal of contaminants is considerably increased.
ATTENTION: Like all vacuum devices, the filter housing PLUS combination must be operated with
corresponding expert knowledge only when operating with harmful substances. The local trade
association will inform you about the required proof of expertise.
ATTENTION: Do not use Dust Stop PLUS in potentially explosive environments.
Design: When the filter system is used in areas, in which people are working, the Trade Association
of the Building Industry in Germany (BG-BAU) requests a 15-fold air exchange.
Circulating air operation: The filter system has to be set up in the centre of the area involved. The
suspended matter stirred up during work and/or use of the room is collected by the continuous air
exchange of the unit and is found in the filter. In this case an air hose should be placed on the air
outlet side or on the suction side in such a way that a ventilation is ensured by the entire area.
Collection at the source Particles should be collected as close as possible to the point of origin.
Basically, quick-running tools should be fitted with dust extraction by means of safety vacuum cleaner.
In order to catch any exceedingly released dusts, the filter housing can be provided with air hoses.
These should be placed as close as possible to the source. This minimises the spread of dust in the
room air. (optionally a holder is offered as an accessory).
Negative pressurisation: The refurbishment area has to be sealed off from the non-affected areas.
This is done by dust protection wall or film doors. The working area should be kept as small as
possible. Hoses are used to pass the filtered exhaust air from the refurbishment area into the open.
The air cleaner can be set up in the refurbishment area as well as in front of the refurbishment area.
Let the filter system run as a vacuum device without interruption whilst the duration of the work.
WARNING - breathing risk: When using Dust Stop PLUS in a closed area, all power sources to open
lighting points, such as fireplaces, boilers, ovens, water heaters and air-conditioning systems, have to
be switched off in order to prevent the risk of the return flow of lethal carbon monoxide.
When the change of filter indicator lights up during work, the pre-filters have to be replaced
immediately. More information is rendered in the chapters titled "Filter exchange" and "Maintenance".
EN
10