Restoring The Factory Preset Programs - Vox StompLab IG Bedienungsanleitung

Setting the type of device that you'll be connecting
to the OUTPUT/PHONES jack and master volume -
[GBL] (GLOBAL)
You can set the type of device that you'll be connecting to the
OUTPUT/ PHONES jack and the master volume of the StompLab.
These settings are common settings for all programs. The
type of device setting will be saved when the power is turned
off. When the power is turned off, the master volume will be
initialized at 7.0.
1. Select [GBL] with the CATEGORY selector.
2. Set the type of device that you'll be connecting to the OUTPUT/
PHONES jack with the VALUE 1 knob.
This setting compensates the output from the guitar amp
model so that it will be suitable for connection to the input
jack of your guitar amp.
A1: Use this setting if you've connected the StompLab to an
amp with a distinctive mid-range character, such as a UK-made
open-backed combo.
A2: Use this setting if you've connected the StompLab to a clean-
sounding amp, such as a typical US-made open-backed combo.
A3: Use this setting if you've connected the StompLab to a
stack-type amp, such as a 4x12 closed-back cabinet.
Ln: Use this setting if you've connected the StompLab to a line
input, to a headphones, to the power amp input of a guitar
amp, or to a recorder.
3. Set the master volume with the VALUE 2 knob.

Restoring the factory preset programs

Here's how to restore (reload) the StompLab's programs back to
the original factory preset programs.
When you perform this operation, all of the programs you
created and stored inside the StompLab will be erased, and
replaced by the factory programs.
1. While holding down the  button and the  button, turn on
the power.

2. The program/value display will indicate " rL ", and the TUNER
#
and LEDs will blink. Take your hand off the buttons you had
been pressing.
If you decide to cancel the reload operation at this point, press
the  button.
3. If you wish to reload the factory settings press the  button.
The program/value display will indicate " Ld " and reloading
will begin. When reloading has completed, the program/value
display will indicate "CP ", and the StompLab will automatically
enter Program select mode.
Never turn off the power while reloading.
11