E) Suction Hose, Extension Tube, Floor Nozzle, Crevice Nozzle; Troubleshooting; Disposal - BASETech 1661489 Bedienungsanleitung

e) Suction hose, extension tube, floor nozzle, crevice nozzle

• Rinse these parts with clean water.
• Clean the outside with a wet rag and a mild detergent.
• Allow the parts to dry in the air.

12. Troubleshooting

Before you undertake measures to eliminate faults, make sure that the device is switched off, the mains
plug is out of the mains socket and the device has completely cooled down.
The product will not switch on.
• Check whether the mains plug is correctly connected. Disconnect the power plug from the power outlet and plug it
back in after 10 seconds.
• Make sure that the outlet is live. Connect another device to the wall outlet. If this appliance also will not switch on,
consult an electrician.
Poor suction power
• Check whether the vacuum cleaner bag is full and replace if necessary.
• Check whether the tube, the hose or the nozzles are clogged.
Motor is unusually loud
• Immediately stop operation of the device.
• Check whether the tube, the hose or the nozzles are clogged.
• If the problem persists, switch the device off. Pull out the mains plug and contact a specialist.

13. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste. At the end of
its service life, dispose of the product according to the relevant statutory regulations.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
34