Mestra R-100127 Anleitung Seite 8

English
- Read these instructions carefully before operating the unit. They contain very
important information about safety during the installation, operation and maintenance
of the unit.
- Keep these instructions for further consultation.
- Check out the state of the unit upon unpacking it.
- Before connecting the device, make sure the voltage in the identification plate
matches the power source to be used. During the installation all the safety
requirements must be observed and the instructions of the manufacturer followed.
- The manufacturer will not be liable for the damage caused by an inappropriate
grounding system.
- Damage caused by a faulty installation or a wrong use of the unit is not covered by
the warranty.
- When in doubt, do not start the unit. Contact the supplier for questions or detailed
information about problems with the unit.
- Always wear goggles and gloves while operating the unit.
- The unit operation generates electromagnetic fields. Do not use the unit if you
have a pacemaker.
- Do not touch the unit or the power cord with wet hands.
- Unplug the unit in case of storm and when you are not going to use it for a long time.
- Place the unit in a dry place, away from dust and water splashes.
- Do not pull, twist or fold the power cord excessively.
- Do not wet the unit; do not use chemical products to clean it.
- Do not touch the electrodes while the unit is working.
- Use the electrode crossheads (F) only for spot welding. To operate in the
"continuous" and "continuous for silver welding" modes, it is obligatory to use the wire
arc holder (A) or the electrodes for manual welding (K); otherwise the machine would
get too hot. ).
- WARNING: to prevent electric shock hazards, connect the unit to a proper power
source (grounded 230 V, 50/60 Hz).
- Unplug the unit immediately whenever you notice an unusual noise, smell or smoke.
- Choose a flat and firm surface to place the unit, away from heat or vibration sources.
- Do not use the unit in damp rooms or near inflammable materials (alcohol,
solvents,...).
- Do not allow children or non-qualified personnel handling the unit.
- Do not dismount, repair or modify the unit.
- Contact the supplier for questions or detailed information about problems with the
unit.
Do not use the continuous mode for more than 5 seconds.