LGB 50110 Bedienungsanleitung Seite 6

USA GB
50110
AC Transformer,
6 Amp, 20 Volt, 230 Volt
50111
AC Transformer,
6 Amp, 20 Volt, 120 Volt
THE PRODUCT
This high-output AC transformer
is the core of the LGB Universal
Power program. It provides 6
amps of AC current for:
- LGB Multi-Train System digital
layouts
- traditional analog layouts with
LGB analog throttles 51070,
52120 and 52121
- AC-powered accessories, like
LGB switches, signals and
street lamps
This transformer features:
- dual, spring-loaded output ter-
minals
- short circuit and overheating
protection
- LED status indicators
- base dimensions (not including
tabs): 160 x 120 mm
THE PROGRAM
With this model, we recommend
the following items:
- 55105 MTS Starter Pack, Type 2
- 51070 Analog Throttle, Indoor, 5
Amp
- 52120 Analog Throttle, Outdoor,
5 Amp
- 51750 EPL Control Box
- 50131 Wire Terminals, 50 pieces
For information on the complete
LGB program, see the LGB cata-
log.
OPERATION
CAUTION! Safety advice:
- Do not use this transformer with
older LGB analog throttles (e.g.,
50070, 50120, 50121, 51120).
Only throttles designed for oper-
ation with AC current may be
connected to this transformer.
- Do not connect two transformers
together (Fig. 1). EXTREME
6
DANGER!
- This transformer should be
inspected regularly for possible
dangers, such as damage to the
cables, plugs or housing. If dam-
age is found, do not use this
power supply. The house current
cable cannot be replaced.
- Disconnect
from house
cleaning the housing.
- Disconnect
from house current if there is a
short circuit. Remove the short
circuit before connecting the
power supply again.
- This transformer is for indoor
use only. Keep it away from
moisture. Do not install it in an
enclosed space.
- Install the transformer on a firm
surface.
- This transformer is for use with
LGB/LEHMANN products only.
- This transformer is not a toy.
This transformer is not for chil-
dren under 8 years of age.
- Save the supplied instructions
and packaging.
Connections
Hint: This transformer can be
used with many different devices
designed to be powered by AC.
Read the instructions for the indi-
vidual device for more detailed
instructions.
Connect the transformer using
the spring-loaded terminals on
the rear of the transformer (Fig.
2). Connect one wire to a "3" ter-
minal and the other wire to a "4"
terminal. Push the button on the
terminal and insert the wire in the
hole.
Hint: Twist the wire ends before
inserting them into the terminal
(Fig. 3). Use the 50131 Wire Ter-
minals to avoid fraying wire ends.
Plug the power pack cord into a
house current outlet.
Indicators
There are two LED indicators on
the front panel. The power indica-
tor (Fig. 4a) glows green when the
transformer
house current. The overheating
indicator (Fig. 4c) glows red when
the transformer is overloaded.
this transformer
current before
this transformer
is connected to