Werbung
Verfügbare Sprachen
Verfügbare Sprachen
L Operating Insrtuction
OPTICAL MOUSE
Remark concerning the installation:
Connect the USB plug of the mouse with
a free USB socket on the PC/notebook
or with a USB hub. The mouse is automatically
detected by the operating system and installed.
This process can last several seconds.
Remark:
The third button (wheel button) can be set with additional
functions by means of a software.
For this purpose, you have to download the required external
mouse driver at www.hama.com and install it afterwards.
USB 2.0 HUB
System requirements:
• Operating system Windows® 2000 from SP 3,
XP from SP 1, Vista or Mac™ OS 10.x
• Free USB connection, preferably USB 2.0
Safety instructions:
You have acquired a high-quality, electronic accessory for your
computer which is universally useable. Please observe the
following points:
• Protect the device against pressure and impact.
• Do not expose the device to moisture. The precision
contacts can be damaged.
• To not connect the device if the device, the
connection lead or the mains adapter are damaged.
• The device or other components must only be
repaired in a specialist shop or in a service centre.
• Only use the enclosed original mains adapter or
original spare parts.
• Only use the enclosed USB connection cable without
extension. Otherwise, the data security can be
affected.
• Make sure that all connected devices are CE-marked.
• Avoid heat sources and direct sunlight exposure.
• Attention! Keep electrical equipment and electronic
devices out of reach of children.
• Attention! Keep packaging materials out of reach of
children! Danger of suffocation!
• Attention! This is an apparatus of the class A. This
apparatus may cause radio interferences in the living
area; in this case, the operator can be demanded to
take appropriate measures.
Putting into operation:
1. Switch on your PC and wait until it has started up.
Connect the USB hub with your PC/notebook by
means of the enclosed USB cable.
2. Please make sure that no terminal device is
connected when you install the USB hub.
Note: When connecting and disconnecting the USB
hub and the USB devices, different messages can
appear on your screen. Contact a specialist or consult
the manual of your computer or operating system if
you have any questions.
3. Now you can connect your USB peripheral devices
(e.g. printer, scanner etc.) to the USB hub. When
installing the devices you have to install every devices
separately, i.e. please wait until the drivers of the
respective device have been completely installed
before installing another device.
4. It is also recommendable – as far as this is possible –
to supply the terminal devices which are connected to
the hub with power of their own.
Note: When connecting the USB hub, you do not have
to install drivers (are included in the operating system
Windows® 2000 from SP3, XP from SP1, Vista or
Mac™ OS 10.x). A driver may be necessary for the
connected USB devices. This one can be obtained
from the manufacturer of the respective device or
when purchasing such a device.
Support and contact information
If products are defective:
Please contact your dealer or Hama Product Consulting
if you have any claims.
Internet/World Wide Web:
Product support or product information can be found
at www.hama.com
Support hotline – Hama Product Consulting::
Tel. + 49 (0) 9091 – 502-115
Fax +49 (0) 9091 – 502-272
e-mail: produktberatung@hama.de
3
Werbung
