Troubleshooting - Niko 352-08994 Handbuch

352-08990 / 352-08991 / 352-08993 / 352-08994
ARCHED LED POST
Read the complete manual before carrying out the installation and activating the system. Keep
the manual for future reference.
1. DESCRIPTION
This is an adaptable and energy-efficient LED post with a stylish design. This LED post is ideally suited to use
outdoors in the garden, on the driveway or to light up the path to your home. With its homogeneous lighting
effect, the post ensures superior lighting in all conditions. As the post is equipped with a built-in PIR sensor, it
only switches on when necessary.
As soon as someone is detected, the light is switched on daylight-dependent. The light only switches on once
the set daylight condition (twilight level) is no longer reached and remains active as long as human movement
is detected.
This manual applies to the following lamp types:
colour
352-08990 light grey
352-08991 anthracite
352-08993 light grey
352-08994 anthracite
The first two posts mentioned are also available with a built-in PIR sensor (see reference numbers 352-02830
and 352-02840).
2. USE
These LED posts are suitable for use both indoors and outdoors. Attach the post to suitable flat ground using
the fittings supplied.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire shall be replaced.
3. MOUNTING
1. Slide the white bar with the wiring clamps out of the post shaft (along the opening at the base).
2. Remove the 2 screws from the cable brace (see fig. 1).
3. Remove the 4 screws in the protective cover to loosen the cover plate (see fig. 1).
4. Place the power supply cable under the cable brace and insert it into the cable inlet in the protective
cover (see fig. 1).
5. Connect the wires as shown in the wiring diagram (see fig. 5 and also § 4).
6. Replace the cover plate on the protective cover and tighten the 4 screws (see fig. 2).
7. Ensure that the power supply cable is nice and straight and then fix the cable brace once again using
the 2 screws (see fig. 2).
8. Slide the white bar with the wiring clamps back into the post shaft.
9. Mark the drill holes on the ground and drill the holes the same size as the plugs provided (see fig. 3).
10. Firmly press the plugs into the drill holes (see fig. 3).
11. Anchor the base firmly onto the ground using the screws supplied (see fig. 3).
4. WIRING
Connect the detector as shown in the wiring diagram in Fig. 5.
Conductor
Neutral conductor
Earthing

5. TROUBLESHOOTING

Malfunction Solution
The light does not switch on. Check the lighting and the fuse.
6. TECHNICAL DATA
Reference
Dimensions in mm (LxWxH)
Lamp type
Nominal power
Nominal voltage
Power factor
Light intensity
Light efficiency
Colour temperature
Protection class
Protection degree
Ambient temperature
Marking
4
EN nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu
dimensions (mm)
85 x 1000 x 190
85 x 1000 x 190
85 x 500 x 190
85 x 500 x 190
352-08990 / 352-08991 / 352-08993 / 352-08994 /
352-08992 352-08995
85 x 1000 x 190 85 x 500 x 190
LED
3 x 3 W
230 – 240 V, 50/60 Hz
> 0.9
720 lm
80 lm/W
3100 K
Protection class I
IP54
-15 – 45 °C
CE marked
7. WARNINGS REGARDING INSTALLATION
• The installation should be carried out by a registered installer and in compliance with the statutory regulations.
• This user manual should be presented to the user. It should be included in the electrical installation file,
and it should be passed on to any new owners. Additional copies are available on the Niko website or via
the Niko support service.
• During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope
of each specific installation.
- the rules of proper workmanship.
This product complies with all of the relevant European guidelines and regulations. If applicable, you can find
the EU declaration of conformity regarding this product at www.niko.eu.
8. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support
service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information can
be found at www.niko.eu under the "Help and advice" section.
9. GUARANTEE PROVISIONS
• The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of
purchase of the product by the consumer. If there is no invoice, the date of production applies.
• The consumer is obliged to inform Niko in writing about the non-conformity, within two months after
stating the defect.
• In case of a non-conformity, the consumer only has the right to a product repair or replacement free of
charge, which shall be decided by Niko.
• Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless
use, incorrect operation, transformation of the product, maintenance that does not adhere to the maintenance
instructions or an external cause, such as damage due to moisture or overvoltage.
• The compulsory regulations of the national legislation concerning the sale of consumer goods and the
protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,
chain stores, distributors, agents or permanent sales representatives, take priority over the above-mentioned
rules and regulations.
Do not dump this product with the unsorted waste. Bring it to a recognised waste collection point. Together with producers
and importers, you have an important role to play in the advancement of sorting, recycling and reusing discarded electrical
and electronic appliances. In order to finance the waste collection and processing, the government levies a recycling
contribution in some cases (included in the purchase price of this product).
L
N
L
N
L' L N
PM352-08990R16314