English; Installation; Before You Begin - U.S. Robotics 7900A Installationsanleitung

English

Installation

Before you begin

Before you begin, we recommend you uninstall or disable any other Network Interface Cards
(NICs) you have in your system. Refer to your old NIC's documentation for removal instructions.
Note: Your model number is 7900A. It is important that you have your serial number written down
before you install the 10/100 Mbps Network Card. You can find your serial number next to the LEDs
on the outside of the bracket of the 10/100 Mbps Network Card and on the side of the package. If
you ever need to call our Technical Support department, you will need this number to receive
assistance.
Model Number
7900A
Note: Touch an unpainted metal area of your computer's case to ground yourself. This will protect
your equipment from electrostatic discharge.
Note: During the Installation procedure, you may be prompted for your Windows Operating
System CD-ROM. Make sure you have that available in case you need it.
Step 1. Install the 10/100 Mbps Network Card
Product ID
USR997900A
All Users:
Make sure that your computer is shut down. Turn off
your computer and all peripheral devices. Unplug your
computer and remove the cover from your computer.
Remove the screw (if equipped) and the expansion slot
cover from a free PCI slot. Insert the 10/100 Mbps
Network Card completely into the PCI slot. If equipped,
secure the 10/100 Mbps Network Card with the slot
screw. After you have secured the 10/100 Mbps
Network Card, replace the cover and turn your PC on.
Serial Number
1