NINCOAIR 200 ALU TEC Bedienungsanleitung Seite 5

TRANSMITTER
Antenna 2,4Ghz
Up / Down
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1.- Open the battery cover.
2.- Fit the batteries (respect polarity).
3.- Close battery cover.
Helicopter:
Switch in position OFF.
When the process finishes the LED will turn on. (Charging time approx. 40 min).
HELICOPTER FLIGHT
Before flight:
1. With the helicopter switched off, first switch on the transmitter.
2. Place the helicopter in the floor. Needed for the proper function of the gyro
3. Switch on the helicopter.
4.The LED flashes. Put the throttle stick to the top once. Ready to fly.
5. Check page 19 for binding process if needed
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Press it clockwise o vice
versa until the helicopter stops turning.
Indicator LED: ON/OF - Charge
5
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Crta. de L'Hospitalet 32
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
Forward / Backward
Left/Right
Turn trim
ON/OFF
HANDBOOK
ENGLISH