KOIOS ST800 Bedienungsanleitung Seite 7

3 .Timer
Press this button to enter the timer mode. You can set time from 1H to 12H and
the step is 1H. After setting the required time, the humidifier will automatically
enter the timer work mode with the time number flickering for three times.
After 12H, press this button again and exit the timer mode.
The corresponding time on the display screen and the unit symbol "H" will show a
white light, which will not be displayed if not in timer mode.
4.Humidistat
Press this button to adjust the humidity which is from 45-90% and the step
is 5%. After selecting the desired humidity, the value on the display screen
will blink for 3 seconds to enter the automatic constant wet mode.
Because of the environment and distance, there is an error between the displayed
degree and the actual degree which is about 5 degrees.
5. Sleep
Press this button to enter sleep mode. And then the sign of sleep mode lights up,
the brightness of display screen becomes half dark, the fog is automatically
changed into middle-grade and humidity to 65% at humidity mode.
Press this button again to cancel the sleep mode and go back to the settings
before. The fog quantitative is changed into high-grade.
6. Anion
Press this button to release a lot of negative ions which could clean the
air and keep you fresh. The negative ions can clearly settle the particles
which are small to 0.01 micrometers and effectively remove odors achieve
the purpose of antimicrobial sterilization.
7 .Water shortage protection
When the water tank is short of water, the buzzer will alarm for three times.
And then the humidifier enters the standby state and the display screen will
show the water shortage icon.
4