Gas Cylinder - GRILL ME NEVADA Anleitung

gas or a 37mbar regulator with propane gas or a regulator with butane/propane mixture at 37mbar or a
regulator with butane/propane mixture at 50mbar or a regulator with butane/propane mixture at 30mbar.
Use a suitable regulator certified to BSEN 12864. Please consult your LPG dealer for information
regarding a suitable regulator for the gas cylinder.
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts
water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are
secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak, which must
be rectified before use.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your gas dealer.
REGULATOR AND HOSE
Use only regulators and hose approved for LPG at the above pressures (See Page 2). The life
expectancy of the regulator is estimated as 10 years. It is recommended that the regulator is changed
within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before
operating the barbecue.
The hose used must conform to the relevant standard for the country of use. The length of the hose
must be 1.5 meters (maximum). Worn or damaged hose must be replaced. Ensure that the hose is not
obstructed, kinked, or in contact with any part of the barbecue other than at its connection.
The hose should not be twisted or kinked when attached to the gas cylinder. No part of the hose should
touch any part of the appliance. So site the cylinder out to the left hand side of the appliance at the
maximum distant permitted by the hose length.
STORAGE OF THE APPLIANCE
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from
the appliance. When the appliance is not to be used for a period of time it should be stored in its
original packaging in a dry dust free environment.

GAS CYLINDER

The appliance can be used with any gas cylinder of weights between 4.5KGS and 15KGS butane and
3.9KGS to 13KGS propane. The gas cylinder should not be dropped or handled roughly! If the
appliance is not in use, the cylinder must be disconnected. Replace the protective cap on the cylinder
after disconnecting the cylinder from the appliance.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder
must never be stored where temperatures can reach over 50°C. Do not store the cylinder near flames,
pilot lights or other sources of ignition. DO NOT SMOKE.
BEFORE USE PLEASE CHECK FOR LEAKS
5