Technical Specifications; Problems And Solutions - D Light Aura Bedienungsanleitung

NOTE:
If large stains appear inside the treatment surface (12) or if the latter is cracked or broken, do not
use the appliance and contact the D Light Service center. After replacing the lamp, always set the
energy level to lower than the one used normally. In the next session, increase the energy level
again only if the there is no abnormal discomfort during or after treatment.
Never immerse the appliance or any of its parts in water!

PROBLEMS AND SOLUTIONS

PROBLEM
The appliance does not start
The contact sensor does not detect the skin
The appliance does not emit pulses
The device buttons are not pressure sensitive Contact our customer support
The status displays the message "error"
- GB
16
CONTROL/SOLUTION
Connect to a better power socket
Contact our customer support
Replace the lamp
Contact our customer support
Check if the display does not blink when in
contact with the skin
Replace the lamp
Contact our customer support
Disconnect and reinsert the light
Replace the lamp
Contact our customer support

TECHNICAL SPECIFICATIONS

Type of Light
Wavelength
Area spot
Energy density
Pulse number
Energy level
Power supply
Rated input power
Net weight
Equipment size
ENVIRONMENTAL SPECIFICATIONS
Operating Ambient Temperature: 10ºC ~ 30ºC
Storage Ambient Temperature: -10ºC ~ 55ºC
Degree of Operation Humidity: up to 80% at 37ºC
Degree of Moisture Storage: up to 90% at 55ºC
Atmospheric Operation Pressure: 700-1060 hPa
Maximum operating altitude: up to 3900 mt.
Do not expose device directly to the sun or other radiation
HR
HR 510nm~1200nm
4.5 cm²
4.7 ~ 6.7 J/cm²
400.000
1 ~ 5
AC100V-240V,50Hz/60Hz
36W
280g
L176 x W74 x H46mm
GB -
17