Using The Callus Remover - Aigostar 8433325185831 Handbuch

GB
Parts Diagram
6
8 9
10 11
DEVICE USE MODES
The product only can be used as a device by rechargeable battery-powered. It
cannot be used with the power directly from the mains.
CHANGING EXFOLIATING HEADS
As the exfoliating head dulls, you may need to
replace it with the additional exfoliating head. With
the unit turned off, press the head release button
and remove the exfoliating head. The new head
will snap into the top of the product .
03
1
2
3
4
5
7
12 13 14
USING 4 IN 1 BEAUTY SET
After selecting the desired head and placing it properly on the main unit always
follow this tree steps:
Remove the protective cap.
Turn the product on by pushing the switch (6) forward.
The product enables you to choose from 3 different functions listed below:
1.Removing callus,
2.Epilating,
3.Shaving & trimming
4.Manicure
CHANGING THE FUNCTION HEAD
Select the appropriate head based on preferred function on 3 in 1 beauty set.
Take the desired head and place it back on the main unit. The head is set
properly when you hear click sound.

USING THE CALLUS REMOVER

This product is designed for removing coarse, callused skin from feet and
heels. Do not use anywhere else on the body. Do not use on broken or
bleeding skin.
Wash and completely dry skin that is to be treated. Remove the cap and turn
the product on and the LED light comes on by sliding the power switch upward.
The exfoliating head will start spinning. Touch the exfoliating head to the area
on your foot that you would like to treat. The LED light will help illuminate
affected area. Press gently at first, and then apply more pressure as you feel
comfortable. If you press too hard, the exfoliating head will stop spinning.
Push the release button (4) on the side
and pull off the preset head as the left
photo.
GB
04