Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
IT
TECHNICAL
CHARACTERISTICS
Voltage ........................................ 220-240 V
Motor power ........................... 1000 W (909)
Sound level .......................... 62 dB(A) (909)
Negative pressure .........................210 mbar
Paper bag capacity ................................ 12 l
Dimensions ..... 320 x 320 x 520H mm (909)
340 x 340 x 570H mm (815)
Weight
9 kg (815 Stainless steel)
Accessories ..........................Ø 32 mm (909)
TYPE OF USE
Use this appliance only as a dry vacuum
cleaner to suck up dust, crumbs etc.
It has only been designed for this use.
DANGER:
The manufacturer can not be held re-
sponsible for any damage due to improp-
er or incorrect use.
Any other use releases the manufacturer
from liability for harm to persons and/
or property and invalidates any warranty
condition.
IMPROPER USE
Do not use the appliance to:
- Suck up liquids of any kind;
- Suck up flammable, explosive, corrosive
and/or toxic substances.
- Suck up hot substances.
Do not use the appliance in areas at risk of
explosion.
900 W (815)
65dB(A) (815)
6 kg (909)
8 kg (815 Plastic)
Ø 36 mm (815)
EN - 4
PREPARING
THE APPLIANCE
Checking the filter systems
-
Release the levers (1 Fig. 1) and remove
the cover (2 Fig. 2) complete with the mo-
tor unit.
-
Remove the polyester filter (3 Fig. 3).
-
Check that the paper bag (4 Fig. 3) is as-
sembled inside the appliance.
-
If the paper bag (4 Fig.3) is not present,
mount it as follows:
909P
Insert the square cardboard rigid part into
the slot on the drum.
815
Fit the paper bag (4 Fig.4) into the noz-
zle (4a Fig. 4) until passing the collar (4b
Fig.4).
-
Replace the polyester filter (3 Fig. 3).
-
Replace the cover and lock it using the
levers (1 Fig. 1).
Assembling the piping
909P
-
Insert the sleeve with bayonet coupling (5
Fig. 5) into the hole (6 Fig. 5), moving the
arrow on the sleeve (5 Fig. 5) to position
"A", then turn the sleeve clockwise until it
locks (arrow in position "B").
-
815
Lift the knob (5a Fig. 5) and insert the
sleeve (5b Fig. 5) in the hole (6 Fig. 5)
until it can't go any further and then re-
lease the knob.
-
Attach the extension (7 Fig.6) to the ergo-
nomic handle (8 Fig.6).
-
Attach the required accessory (suction
tool, dusting brush, crevice tool, mul-
ti-purpose brush etc.) to the rigid exten-
sions (9 Fig.7).
Werbung
Inhaltsverzeichnis
