Axis Q87-E Installationsanleitung Seite 7

AXIS Q87-E 230/120 V AC Installation Guide
Install the Power Supply
The mains supply shall be disconnected during installation.
The supplied power supply shall be used. Using any other power supply will void the warranty
and could leave the unit at a risk.
The day/night sensor is attached to the power supply. If using the day/night sensor, place the
power supply so that the sensor can track the changes in daylight.
1. Install the power supply in the desired location. Make sure that the screws and plugs are appro-
priate for the material (e.g. wood, metal, sheet rock, stone).
2. Unscrew the lid screws and open the power supply.
3. Route the network, power and, if applicable, the illuminator cables through the cable glands in
the PTZ base.
Page 7