Operation - SeaLand DTD01 Einbauanleitung

Installation
6.2 Key to DTD01 - discharge pump system wiring
Ref. Description
A DTD01 control panel
B Discharge pump
C 12 or 24 V DC
D V DC ground
1. Use 14 gauge or larger diameter standard copper wire.
2 . Maximum discharge pump circuit breaker or fuse rating: 20 amps .
6.3 Key to DTD01-DTM04 system wiring
Ref. Description
A DTD01 control panel
B Discharge pump
C DTM04 indicator panel
D Wastewater tank
E 12 or 24 V DC
F V DC ground
G Discharge pump circuit breaker or fuse
H 12 V DC
I 24 V DC
J 1-amp circuit breaker or fuse
K Toilet system circuit breaker or fuse
1 . Heavy line indicates 14 gauge or larger stranded copper wire is required .
2 . Other wire can be 18 gauge stranded copper wire or larger .
3 . Maximum discharge pump circuit breaker or fuse rating: 20 amps .
7

Operation

7.1 OPTION 1: DTD01 discharge control panel only
1 . When boat is in unrestricted waters and pump-out is desired, insert key into switch and turn to
momentary "Start" position (1).
2. Allow key to rebound to "Pump On" position (2). Green light indicates that pump is running.
3. When pump-out is complete, turn key to "Off" position (3) and remove key from switch.
8
Dometic Tank Discharge Control
(fig. 5 , page 3)
5
Ref. Description
E Discharge pump circuit breaker or fuse
F Red
G Black
H Brown
(fig. 7 , page 4) 7
Ref. Description
L + V DC to electric toilet system
M Full level probe
N Mid level probe
O Low/Empty level probe
P Red
Q Black
R Brown
S Green
T Blue
U Yellow
V Orange
(fig. 4 , page 3)
4