Recycling; Data And Product Specifications - FACECOVER TIKI Bedienungsanleitung

11. Recycling

The mask
is composed of PET and TPE materials, and is re-
cycled according to local ordinances. When this should be
done can be determined by either a regular system check
of the mask and/or a disposal schedule. If the device was
used in a hazardous environment there may be hazardous
particles on the mask. It may need to be disposed of as
hazardous goods. Please dispose of according to local, state
and federal laws.

12. Data and Product Specifications

The Tiki Respirator is a positive pressure variable airflow pu-
rifying respirator that adjusts airflow according to demand.
It is designed to be used in an environment that has normal
oxygen content for breathing and no chemicals or particles
requiring special filters.
The Tiki Respirator unit consists of:
Face mask (Fig 1a, page 2)
Small, medium and large. The mask should be disposed of if
contaminated. The mask is composed of PET and TPE.
Harness (Fig 1d, page 2)
The harness is made from elastic webbing and nylon clips.
This can be reused unless it is exposed in hazardous
environments, to contagious pathogens or other harmful
particles.
Blower unit (Fig 1c, page 2)
The blower contains the fan, the work lights and the opera-
tional buttons and warnings. It automatically adjusts airflow
according to demand inside the mask. The blower contains
a lithium polymer battery that will run the blower for a
minimum of 60 minutes.
Do not use the Tiki Respirator in explosive environments. Use only accessories manufactured by Facecover Sweden AB.
Batteries:
The blower unit and the external battery pack both contain
lithium polymer batteries. It is therefore necessary that the
following precautions be followed:
• Do not dispose of in fire or subject to extreme heat.
• Do not disassemble.
• Do not use if there is any sign of mechanical damage.
• Do not use in heavy rain or submerse them in liquid.
• Do not charge in less than 0°C.
The P3
particle filter is composed of ABS plastic and
HEPA fibreglass media. Please note that depending on the
environment it has been used in, it can contain dangerous
particles and will therefore have to be disposed of according
to local ordinances and regulations.
The blower
unit and external battery both contain electri-
cal equipment and a lithium polymer battery. These should
be recycled or disposed of according to local regulations.
P3 particle filter (Fig 1b, page 2)
When purchased, the Tiki Respirator includes only a particle
filter and should not be used in areas that contain gaseous
solvents and other hazardous airborne contagions that a P3
particle filter will not remove. The particle filter is composed
of ABS plastics and HEPA fibreglass media.
Battery charger (Fig 1e, page 2)
The battery charger is for charging the blower unit and the
external battery pack. These must be charged separately.
Never charge batteries when the battery temperature is less
than 0°C.
External battery pack (Sold separately) (Fig 1g, page 2)
The external battery is a clip-on unit containing a lithium
polymer battery. It connects to the blower unit using a cable
with a screw fitting. This will increase the battery life for a
minimum of 6 hours*. Battery cable is included.
(*Provided the seal check and fit testing has been performed
successfully. Test conducted at 20x1.5L/min sinusoidal).
Unit operational temperature -10°C to 45°C. Charging
temperature 5°C to 30°C.
Do not operate if more than 90% relative humidity.
Approval: EN 12942 TM3P R SL, CE 0158
WARNING
In the unlikely event that the batteries are damaged and
electrolyte seeps out, keep away from eyes.
If electrolyte comes in contact with eyes, flush with water
and seek medical attention immediately.