Appliance Description; Standard Delivery; Installation; Temperature Limiting/Anti-Scalding Protection - Stiebel Elron DHB-E 13 SLi electronic Bedienung Und Installation

installation

appliancE dEscription

8. Appliance description
The bare wire heating system is suitable for hard and soft water
areas. The heater has low susceptibility to scale build-up.
The outlet temperature can be infinitely adjusted. The electronic
control unit enables automatic matching of the electrical output
corresponding to the selected temperature subject to the actual
throughput.
8.1

Standard delivery

— Mounting bracket
— Installation template
— Twin nipple
— Cross-piece
— Tee
— Flat packing
— Sieve
— Flow limiter
— Plastic profile washer
— Plastic cap
— Flexible plastic couplings
— Cap and back panel guides
8.2 Installation
The following conditions have been prepared for the appliance
at the factory:
— Power supply from "below", installation on unfinished walls
— Water connection, installation on unfinished walls
The appliance must be fitted vertically, over or undersink, to a
solid wall.
8.3

temperature limiting/anti-scalding protection

The maximum temperature can be limited to 43 °C via the user
interface on the appliance cap. The following steps are necessary
for this procedure:
»
Remove the appliance cap.
»
Remove the electronic PCB from the user interface on the
appliance cap. Be careful of the snap-on hooks.
»
Move the plug from left to right (position "43 °C").
»
Refit the user interface, ensuring the snap-on hooks click into
place. Observe the positions of the pushbutton and shaft.
24 |dhB-e ... sil electronic
Setting the temperature limit / anti-scalding protection
8.4

Installation versions

The following installation versions are possible/permissible:
— Power supply for unfinished walls - from above
— Power supply for finished walls
— Water installation for finished walls
— Installation with repositioned appliance cap
— Installation for offset tiles
— Installation of a load shedding relay
8.5

Special accessories

8.5.1 twin-lever taps (mains pressure)
wKmD - Kitchen taps
— , part number 222437
— wBmD - Bathroom taps , part number 222438
Installation accessories
8.5.2
— undersink installation pipe assembly
Connections: Finished walls, G 3/8", above.
— 2 pce. G ½" water plug set
These plugs are required for third party pressure valves.
8.5.3 Installation sets for installation on finished walls
— Solder fitting - copper pipe
x G ½" water plugs and 2 x union nuts ½" with insert for solder
fitting Ø 12 mm.
— compression fitting - copper pipe
2 x G ½" water plugs and 2 x compression fittings ½" x 15 mm,
plus gaskets.
compression fitting - plastic pipe
—
comprising: 2 x G ½" water plugs and 2 x compression fittings ½"
x 16 mm (Viega: Sanfix-Plus, or Sanfix-Fosta), plus gaskets.
8.5.4 universal mounting frame
Part number 220291, comprising: Mounting frame with electric
wiring. This set creates a gap of 30 mm between the back panel
of the appliance and the installation wall. This enables the power
supply to be freely routed over unfinished walls behind the
appliance. This increases the appliance depth by 30 mm. This set
reduces the protection to IP 24 (splashproof).
, part number 070565,
, part number 074326.
, part number 074019, comprising: 2
, part number 222380, comprising:
, part number 222381,
www.stiebel-eltron.com