Clas Ohlson R0084-N-UK Bedienungsanleitung Seite 5

Setting the time, 12- or 24-hour clock and snooze time
1. Plug the mains adaptor both into a power point and the clock's power socket.
2. Press [ SET ]. The hours display will then begin to flash. Press or hold in [ ▲ ] or [ ▼ ]
to set the hours.
3. Press [ SET ] again and the minutes display will begin to flash. Press or hold in [ ▲ ]
or [ ▼ ] to set the minutes.
4. Press [ SET ]. The "12H" symbol will then begin to flash. Press [ ▲ ] or [ ▼ ] to select
a 12 or 24 hour time display.
5. Press [ SET ] again. The "05" symbol will begin flashing. Press [ ▲ ] or [ ▼ ] to set
the snooze time (5-60 minutes).
6. Press [ SET ] again to save settings and to return normal time display. If no button is
pressed for 10 seconds, the clock will automatically return to normal time display.
Note: If the 12-hour clock display is chosen the "PM" symbol will be used for PM time
display. The "AM" symbol is not used or displayed.
Setting the alarm
1. Press [ AL1•2 ]. Both "A1" (alarm 1) and the hours display will begin to flash.
Press or hold in [ ▲ ] or [ ▼ ] to set the hours.
2. Press [ AL1•2 ] again. The minutes display will begin to flash. Press or hold in [ ▲ ]
or [ ▼ ] to set the minutes.
3. Press [ AL1•2 ] again. "OFF" will appear. Press [ ▲ ] or [ ▼ ] to select the type of
alarm or "OFF".
- rd: radio
- bu: buzzer
- OFF: No alarm
4. Press [ AL1•2 ]. Both "A2" (alarm 2) and the hours display will begin to flash.
Press or hold in [ ▲ ] or [ ▼ ] to set the hours.
5. Repeat steps 2 and 3 as listed above.
If you have selected the radio or buzzer alarm for alarm 1 and/or 2, either A1 and/or
A2 will be displayed depending on the corresponding alarm/s you have chosen.
Switching the alarm off
1. Press [ AL1•2 ] when alarm 1 or 2 sounds in order to turn off the alarm. The alarm
will go off again at the same time in 24 hours time.
2. If [ NAP▲ ] or [ RADIO/SL ] is pressed when the alarm goes off, the nap function or
the radio will be switched on and the alarm will be switched off.
Snooze
Press [ ] to activate the snooze function when the alarm goes off. The alarm
will sound again after a short delay determined by the set snooze time, refer to
the Setting the time, 12- or 24-hour clock and snooze time section above.
5