Cleaning; Technical Data; Disposal - Hyundai FS 996 Gebrauchsanleitung

Cleaning

ATTENTION!
❐ Risk of injury associated with sharp blade! Never touch the cutting surface of the
cutting blade; instead always grasp the holder.
❐ Pull the mains plug out of the socket before you clean the device!
❐ Danger of electrocution! Never immerse the device in water or other liquids and
never hold it under running water. Never touch the device, cord or plug with wet hands.
❐ Caution! Damage to the device! The device and the accessories are not suitable
for the dishwasher!
❐ The surfaces could be damaged as a result! Do not use any aggressive or abra-
sive cleaners or cleaning pads.
1. Take the fi nger guard and slicing carriage off of the device (see chapter "Use", section
"Before slicing").
5. Dry off all parts.
6. Insert the cutting blade back in the device and tighten the locking screw by turning it
counterclockwise.

Technical data

Product number: Z 00166
Model:
Voltage supply:

Disposal

The packaging material is recyclable. Dispose of the packaging in an environ-
mentally-friendly manner and make it available to the collection service for re-
cyclable materials.
Dispose of the device in an environmentally-friendly manner. Dispose of it at a
recycling centre for old electrical and electronic devices.
For more information, please contact the administration in your community.
Customer service / importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.
2. Turn the locking screw (5) clockwise to loosen the cutting
blade.
3. Carefully remove the cutting blade.
4. Wipe off the device and accessories with a damp cloth.
You can also wipe off the fi nger guard, slicing carriage and
cutting blade with water and a mild detergent.
FS 996
220 - 240 V AC, 50 Hz
Output:
Safety class:
Slice thickness:
Short-time operation: 5 minutes
16
100 W
II
0 – 15 mm