Operation - Denon Fitness Pack Schnellstartanleitung

Operation

Headset Microphone Setup
To use the included headset microphone, follow these setup steps:
1. Ensure new batteries are installed in the beltpack transmitter.
2. Connect the headset microphone to the beltpack transmitter.
3. Pair the beltpack transmitter to the wireless receiver.
a. Turn on the receiver.
b. Turn on the beltpack transmitter.
c. Select a channel with the best reception on the receiver.
d. Lift the cover from the compartment and place the beltpack transmitter IR
sensor near the receiver's IR LED. Press the Set button on the receiver.
Wait for about 3 seconds until the IR LED stops flashing. When it finds an
interference-free channel, the RF LED will illuminate on the receiver to
show that the beltpack transmitter is matched to that channel.
4. Adjust the microphone gain on the receiver.
5. As you speak, watch the AF indicator on the receiver to make sure a signal is
being received.
3