Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Safety
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket (incl. fixing screw and nut)
9.
Installation
9.1
Installation conditions and preparations
CAUTION Injury
!
Install the appliance out of the reach of children.
- Only install the appliance in protected outdoor areas.
- Never install this appliance on or below combustible
materials.
- Never install the appliance directly below a socket.
- Install the appliance on the wall or ceiling.
- Observe the specified minimum clearances (see chapter
"Specification / Dimensions"). This appliance gives off radiat-
ed heat. Therefore ensure that there are no objects between
the appliance and the person or objects to be heated, such as
furniture, for example.
- Wood ceilings may become hot even if the minimum clear-
ances are observed. Dark spots or fine shrinkage cracks on
wooden ceilings may therefore occur.
www.stiebel-eltron.com
319414-40281-9269_IA 2024 outdoor_de_en_fr_nl.indb 13
9.2
Power supply
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
- The appliance must be able to be separated from
the power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
- An external socket must be able to be isolated from
the power supply across all poles.
- Always equip the supplying power circuit of the ap-
pliance with an RCD (nominal earth leakage current
≤ 30 mA).
Note
Observe the type plate. The specified voltage must match
the mains voltage.
f Only connect the appliance to a correctly installed mains
f
socket.
We recommend a dedicated fuse for this appliance (see chapter
"Specification / Data table"). From 3600 W upwards, only ever
connect one appliance per fuse.
9.3
Appliance installation
Note
Check in chapter "Specification / Data table" whether you
are able to install the appliance vertically or horizontally.
f Secure the mounting bracket on the wall or ceiling using
f
suitable fixing materials.
f Secure the appliance to the mounting bracket using the
f
screw and nut provided.
f Route the power cable from the appliance either towards the
f
back, top or bottom.
9.4
Adjusting the tilting angle
The tilting angle can be adjusted over a range of 100°. We recom-
mend a setting of 45°.
CAUTION Burns
If the appliance is already in use, let it cool down before
adjusting the tilting angle.
f Undo both screws on the pivot hinge.
f
f Set an appropriate tilting angle.
f
f Retighten the two screws again.
f
Material losses
!
Ensure that the appliance does not come into contact with
the power cable.
IA 2024 outdoor |
13
01.11.2017 10:54:23
Werbung
Kapitel
Inhaltsverzeichnis
