Product Overview - Power Walker AVR 1200 Schnellstartanleitung

EN
1. Introduction
Thank you for purchasing PowerWalker product. This series is designed to automatically maintain a
constant voltage level to protect sensitive electronics from brownouts and overvoltages. With its
fashionable and flexible cabinet, it can be installed on a desk or wall without causing an unsightly or
unprofessional image, and will perfectly utilize a limited working environment. This series offers
one-step boost and one-step buck stabilizer to continuously supply a clean power source to its
connected equipment.

2. Product Overview

1. Output receptacles (for connected equipment)
2. AC Input
3. Circuit breaker
4 .Modem/phone line surge protection
Wall Mount the Unit
The unit can be mounted to a wall surface. Please follow below steps:
1. Use tape to hold this page in place against the wall.
2. Use a sharp nail to puncture the center of the two holes to mark the wall.
(see below chart 1)
3. Mount the unit by positioning the key-hole slots over the mounting nails.
(see chart 2)
5. Power Switch
6. Power LED
7. Boost/Buck LED