Front panel connections require:
Power supply 24 VDC ± 15% 500 mA max.. Use unipolar cable with 0.5 mm maximum cross-section.
Do not attach lug.
Bipolar analog outputs ±10V, use shielded cable with 0.5 mm maximum cross-section.
Do not attach lug.
Connect the shielding directly to the grounded plate and as close as possible to the module.
80128B_MHW_R-DAX_0508_ENG
4 • INSTALLATION
5 • CONNECTIONS
Yellow Power LED
Green Run LED
Red Fail LED
+24Vdc
LOAD 500Ω min.
LOAD 500Ω min.
LOAD 500Ω min.
LOAD 500Ω min.
24Vdc
± 25%
500mA max
Internally connected
5