CampTrails Cabin Creek Benutzerhinweise

User instructions:
Cabin Creek
Directly after purchase
1. Choose the right tent pegs
Important: Different camping grounds require different pegs (plastic for clay; metal for rocky;
wood for sand). Your CampTrails tent contains 1 type of top quality pegs for general usage. To
ensure secure setup of your tent, when you expect to camp on different grounds during your
trip(s), please buy the appropriate pegs at your dealer's in advance.
2. Do a trial-set up of your tent.
Please set up your tent prior to your first trip to ensure you are familiar with the setup and the
tent is in proper condition.
Tent set-up instructions
(We recommend 2 people)
Important: Inspect the chosen site and clear all sharp and/or protruding objects that
can damage the tent floor. Be sure the site will offer proper drainage of rainwater
away from the tent. When choosing a site try to pitch the tent in a shaded area.
1) Unroll the tent separating the components. Assemble the poles ensuring ferrules are fully
connected. You will have two (2) equal length long main frame poles and two (2) poles
of two different lengths.
2) Spread out the tent, locate the pole sleeves that run diagonally. Insert the 2 long main
frame poles into these sleeves. Always push poles through sleeves (even when taking
down) to ensure ferrule connections are complete. Pulling can separate at ferrules with
potential pole breakage when flexing. Poles when inserted through sleeves will form an
X pattern on the still flat tent.
3) Insert the longer of the leftover poles through the pole sleeve going side to side across
the tent, located towards the middle area of the tent. This pole should cross under the
main frame poles.
4) Insert the last pole through the pole sleeve located at the end of the tent . All poles will
now be fully inserted through sleeves and the tent is still flat on the ground.
5) At this point one person needs to lift the tent where the two main frame poles cross to
help getting the tent up. The second person will be able to move around the tent making
the pole to tent connections.
6) Now connect the two main frame poles at the front corners with the ring pin system.
Europe distribution: Nigor Net B.V., Utrecht, The Netherlands
ENGLISH VERSION
7) Move to the other end of the main frame pole and Flex the pole in order to
make a hoop and connect it to the ring pin connection. Mind that you are using
the correct ring pin connection, as the poles cross here. You need the third ring
pin connection from the front.
8) Repeat step 7 for making the connections for the second main frame pole.
9) Now work with shorter poles. Flex one end and connect it to the ring pin
connection. Flex and insert the other end on the opposite side.
10) Move around the tent attaching all the clips to the frame.
11) Position the tent in desired location and stake securely.
Tent care
We strongly advise you to read the leaflet including warranty and detailed tent care
information before first use!!

Floor protection: We recommend the use of a thin groundsheet or floor saver
with any tent for added protection from abrasion. The floor saver should be
about 10cm. (4 inches) from the tent edge to avoid the possibility of
channelling water beneath the tent.

Damaging substances: Fuels can damage tents as can DEET found in many
insect repellents.
 Exposure to sun: The sun's UV rays can be harmful even with technical
advances in fabrics. Prolonged exposure could result in fading and possibly
fabric disintegration. Do not leave a tent up longer than necessary.

Cleaning: Clean tent fabric, poles and zippers with lukewarm, clean water after
every use. Never use detergents, washing machines or dryers (also see warranty
leaflet).

Tent storage: It is important that you store the tent in a dry and cool condition.
If you put the tent away in the carry bag while it is wet, even for a short time, it
may become affected by mildew, which can damage the coating.

Seams: All major seams are factory taped. Over time seams could experience
delamination. Simply clean the seam and apply seam sealer that can be
purchased at most outdoor stores.
T+31 88 0999899 F+31 30 2809509 E info@nigor.net U www.camptrails.eu