Chal-Tec ACO-MCH1 Bedienungsanleitung Seite 10

5. Cool button
NOTE: The function of Cool can be set only under the fan operating.
1) Before operating the unit in Cool mode, make sure that water tank is properly fixed. Then proceed to add
clean water into the water tank. While adding the water, make sure that you keep an eye on the water level
indicator to make sure that you do not OVER or UNDER FILL the unit. Press the button Cool after you have
added the water and the unit should commence to blow cooler air.
6. Timer knob can set 0-120 minute
2) If you find that the air after Step 1) is still not cool enough, you can add additional ice block into the water
tank or ice basket directly by drawing out the water tank. Be sure not to exceed the water tank capacity
otherwise damage to the unit or electric shock may occur.
Note: Before using the Ice Block, firstly you must remove the lid from Ice Block box and add clean water into
the Ice Block box until reach the water level scale, then turn the lid
for 15 minutes; secondly you should place it in your refrigerator and let the Ice Block
freeze for 1 to 2 hours.
3) You may complete pull out water tank, then replace water in the water tank or clean water tank
6. How to knock down the dust-proof bracket and honeycomb filter
1
2
8. To turn off the unit just press the button OFF.
9. To completely shut the unit off, turn all the controls to OFF, and remove plug from the socket-outlet.
3. pull out the dust-proof bracket
4. rotate the knobs outwards like left image
back to the Ice Block box and wait