Remote Controller; Auto Detect - Daikin MERCA Bedienungsanleitung

3.0 INSTALLATION OF LCD REMOTE CONTROLLER
3.1 Accessories
The following accessories are included together with this manual. If any part is missing,
contact your dealer immediately.

1 Remote controller

2 Wooden screw 4.1 x 16 (2 pieces) & machine screw (2 pieces)
3 Instruction manual
4 Battery
5 Connection wire
3.2 Step-by-step guide
i) First, open up the casing of the LCD remote controller into its top and bottom case
using a screwdriver. To do this, insert the screwdriver into the lower slot and slide it in
the outward direction.
ii) Fix the bottom case onto the wall with the 2 wooden screws provided.
Then, insert the 4-pin connection wires (from main board) through the slot on the upper
center of the case as shown below.
iii) To select cooling only model or heatpump model, some adjustment required in the
shunt jumper setting.
iv) Fasten back the top and bottom case into place. Hook the two upper claws into their
respective slots and snap the lower part shut.
Lower slot
for opening LCD
casing
SHUNT JUMPER SETTING FOR MODEL SELECTION
J H
OFF
OFF
SET
SET
* The AUTO DETECT is unavailable for Chilled Water (CW) System.
OM-NET3-0906-Daikin_EN
LCD Remote
2 x Wooden
screw
LCD Remote
(Bottom case)
JD Application
OFF

AUTO DETECT

SET CW & DX system
OFF CW & DX system
SET AUTO DETECT
4
4
(Top case)
Connection
Model/Remark
Depends on main board
Export cool (EC)
Heatpump (HP)
Auto heatpump (AP)
3/5/07, 9:58 AM
wires