General Guidelines - Perel Tools WTC180T Bedienungsanleitung

•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
3.

General Guidelines

•
Protect this device from shocks and abuse. Avoid brute force when operating the device.
•
Protect the device against extreme heat and dust.
•
Familiarise yourself with the functions of the device before actually using it.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
4. Features
•
for ceramic floor and wall tiles
•
water cooled blade
•
adjustable blade angle
5. Overview
Refer to the illustrations on page 2 of this manual.
tile cutter
A On/Off switch
B adjustable bridge
C tile positioner with adjustable angle
C1 lateral lock knobs
C2 tile holding edge
C3 angular lock knob
D tilt angle lock knob (2x)
6. Installation
•
First assemble the table frame [J]. Place the top part upside down on the floor (narrow edge of L-
shaped frame facing down: ┌ ┐ ) and mount on each corner a leg with 4 bolts (screw hand tight).
•
Place a rubber foot on each of the four legs.
•
Turn the table frame upright (resting on the 4 rubber feet).
•
Tighten all the bolts firmly and verify that the table frame is stable.
•
Place the frame on a level, steady, non-slippery surface.
•
Place the water reservoir on the frame.
•
Locate the position of the water pump [L] in the water reservoir. Place the pump [L] as shown in the
illustrations on page 2 and press it down until it snaps into place.
•
Fill the water reservoir, making sure that the pump inlet is completely under water. Do not operate the
tile cutter with an empty reservoir or too low water level.
•
Place the table with adjustable bridge [B] on top of the water reservoir. Make sure the cables from the
water pump [L] are not squeezed.
7. Operation
•
Always wear safety goggles, safety gloves and ear protection when operating the tile cutter!
•
Make sure the On/Off switch [A] is in the off-position and connect the power cord to the mains.
•
Place a tile against the graduated ruler [F] or use the tile positioner with adjustable angle [C] to place
the tile under an angle. Loosen the lateral lock knobs [C1] to move the positioner lateral, loosen the
angular lock knob [C3] to set the desired angle and tighten the knob [C3]. Place a tile against the tile
holding edge [C2] and tighten the lateral lock knobs [C1] to secure the tile position.
•
Make sure the cutting disk [I] doesn't touch the tile and switch on the tile cutter by pressing the on/off
switch [A]. Wait a few seconds to allow the disc to reach full speed. Make sure that water is sprayed on
the disc. If not, switch off the machine and check the water level and pump [L].
V. 02 – 09/01/2013
WTC180T
E tilt angle indicator
F graduated ruler
G handle
H cutting disk guard
I cutting disk
J table frame
K blade guard holding screw (2x)
L water pump
4 ©Velleman nv