Status Indicators - BeeWi BBS010 Bedienungsanleitung

Check the connection by placing a call from your phone.
Note: If the pairing cannot be completed within 2 minutes after the pairing
mode is activated, the speaker will power OFF automatically. Repeat the
steps above to pair the speaker and mobile phone again.

2.5. Status indicators

Status
Power On
Power Off
Pairing
Standby mode
(Connected)
Standby mode
(Disconnected)
During Communication
Low Battery
Charging
Charging Completed
2.6. Connection
The speaker automatically connects to the last connected device when it is
turned on. If the device is not found, the speaker will connect to a previous
device in the paired list.
In case the connection is not made automatically, it is possible to reconnect
manually either from the speaker by pressing the mFB or from the mobile
device (refer to the phone user manual). It is also possible to disconnect
the speaker either manually or by moving out of range. When losing the
connection/link, the speaker will automatically power off after 15 minutes.
LED
Blue
Red
Blue/Red
Blue
Blue
Blue
Red
Red
Red
Descriptions
3 seconds flash
3 seconds flash, then Off
Alternated blinking
Blinking every 3 seconds
Blinking twice every 3
seconds
Blinking every 6 seconds
Blinking every 3 seconds
Light on
Light off
ENGLISH
7