Inserting/Replacing The Battery - Dimavery SGB-100 Bedienungsanleitung

OPERATION

Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
Functions
To turn on/off or to change to tuning mode, press the ON/OFF button.
When turning on, the LED light flashes from 7B to 1E, tuning mode is for guitar and the green light will flash.
By pressing the button again, the tuning mode changes to bass mode and the red light will flash.
Press the button once again, the tuner will be turned off and the LED light flashes from 1E to 7B.
The tuner will turn off automatically after about 10 minutes without any sound input.
Tuning
When tuning, the LED light will be on to indicate the note and the accuracy.
When the note is less than 5 percent accurate, the upper central green light will light up.
If the note is more than 5 percent inaccurate, the upper right red light will begin to light up, together with the
central green light.
The lighting degree of this upper light will change as the note accuracy changes.
When the accuracy difference is more than 30 percent, the upper central green light will be off and the side
red light will be on for the strongest degree.
9/10 26300010_V_1_0.DOC