EN
DIGITAL INSTANT READ THERMOMETER
INSTRUCTION MANUAL
Product Image
Manual
1.
Press Automatic bounce:
Press the Bounce Button to automatically pop up
the probe.
2. Display: Displays the current temperature.
3. Start Button: Powers on unit. When unit is in FAST CALC lock mode, press start
again to unlock the display and change to NORMAL mode.
4. Stopper Lock: Holds the temperature probe in place when fully extended. Always
fully extend the probe so it locks securely in place.
5. °C/°F Button: Press the °C/°F Button to select which temperature unit to display.
6. Temperature Probe: Insert temperature probe into meat to receive internal
meat temperature.
7. Reset Button: If the unit is not operating properly, press the Reset Button to reset
the device.
8. Battery Compartment: Holds one 1 AAA battery to power the unit.
Model No. TP-03
TP- 03
-1-
BEFORE FIRST USE
Insert or Replace Battery : Insert AAA battery (included) in correct polarity
(+) and (-) as indicated.
Clean stainless tip: wash tip with warm soapy sponge or cloth, then rinse and dry.
Do not immerse product body in water.
READ ALL INSTRUCTIONS, PLEASE.
The thermometer is now ready to use.
GETTING STARTED
Press the button to release the probe (Picture 1).
Press the"START" button to Turn ON.
TO CHOOSE °C/°F
Press the °C/°F button to select the temperature unit.
TO MEASURE FOOD TEMPERATURE
The unit has two ways to get an accurate temperature reading: FAST CALC
NORMAL.
The FAST CALC system speeds up the by using sequential mathematic calculations
based on rate of temperature rise, to project an estimated final reading before it is
actually reached.
The NORMAL system displays the actual tip temperature as it rises, which takes
more time depending on temperature differential.
To measure food temperatures with the thermometer.
1. Turn unit ON by pressing Start button.
2. Insert tip of probe into food being cooked. The thermometer will start processing.
a . W h e n t h e t i p i s c o l d a n d i s i n s e r t e d i n t o f o o d a n d b e g i n s a r a p i d r i s e i n
temperature (due to a large difference between the cold tip, and the hot food
temperature) the unit automatically chooses FAST CALC processor mode.
It will BEEP as it starts Fast Calc.
b. When the tip is already hot, or detects a smaller difference in temperature,
the unit stays in NORMAL mode.
-2-
and