Maintenance; Brush Replacement; Warranty - Normfest ASSA18V Originalbetriebsanleitung

screw too much and break it.
▪ Tightening with the impact driver not aligned with the
screw may damage the screw head and the driving
force will not be transmitted properly to the screw.
▪ Before screwing large long screws into hard material,
it is advisable to pre-drill a pilot hole with the core di-
ameter of the thread to depth approx. 2/3 of the screw
length.

Maintenance

WARNING: Always set the forward/reverse
switch (4) in central position before any work on the
machine e. g. fitting and removing a battery, tool
change, transport, maintenance and storage.

BRUSH REPLACEMENT

This power tool is designed for quick brush replacement.
When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes
at NORMFEST service centre for warranty and post-
warranty service.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service or-
ganisations, always using genuine replacement parts.
Original instructions

Warranty

The guarantee period for NORMFEST power tools is de-
termined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective NORMFEST power tools
will be recognized if the machine is sent back to the
dealer or is presented to the authorised warranty service
centre undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to change specifica-
tions without notice.
Specifications may differ from country to country.
15
EN