Cotech 52008x36 Bedienungsanleitung

Outdoor IP44 Receiver Switch
Art.no 36-6013 Model 52008x36
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
• Make sure that the electrical socket that the product
is plugged into is easily accessible in case it and
the connected product need to be quickly disconnected
from the mains electricity.
• Do not connect products of this type to each other.
• Do not cover the product.
Specifications
Mains power supply 230 V AC, 50 Hz
433.92 MHz
Frequency
Max range 25 m
Load (resistive bulb) 0–3680 W
Load (inductive) 0–613 W
UNITED KINGDOM • CUSTOMER SERVICE tel 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZ
Operation
Installation
1. Plug the receiver into an electrical
outlet.
2. Hold in the button on the front of
the receiver for at least 3 seconds
and then release it.
3. The button's LED will begin
flashing slowly. The receiver is
now ready to be paired with
a transmitter.
4. Pair the receiver to the transmitter
by following the instructions
accompanying your transmitter.
Up to 6 transmitters can be paired
with the receiver.
5. Plug a light into the receiver and
check that it is turned on.
6. The light can now be controlled by
using a transmitter.
Note: The light can also be switched on/off manually by
pressing the button on the receiver.
Unpairing all paired transmitters
1. Hold in the button on the front of the receiver for 6 seconds
until the LED button starts flashing quickly.
2. When the LED stops flashing, all the transmitters which
were paired with it will have been unpaired.
Unpairing one paired transmitter
1. Hold in the button for 3 seconds on the front of the receiver
you wish to unpair and then release.
2. The LED button will start flashing slowly. The receiver is now
ready to unpair from the transmitter.
3. Press in the [ OFF ] button on the transmitter (make sure
to choose the correct [ OFF ] button if the transmitter can
connect to multiple receivers). The transmitter will now
unpair from the receiver.
Care and maintenance
• The receiver should be unplugged from the wall socket if it
is not to be used for a long time.
• The receiver should be cleaned by wiping it with a dry cloth.
Troubleshooting guide
The receiver is • Has the receiver been paired with
not working, a transmitter as described above?
the LED is Try pairing them again.
not lit.
• Check that the light is properly plugged
into the receiver and that it is switched
on and not faulty.
• Try plugging the light into another electrical
outlet to make sure that it works.
• Is there electricity at the outlet where
the receiver is plugged into?
Responsible disposal
This symbol indicates that this product should
not be disposed of with general household
waste. This applies throughout the entire EU.
In order to prevent any harm to the environment
or health hazards caused by incorrect waste
disposal, the product must be handed in for
recycling so that the material can be disposed
of in a responsible manner. When recycling
your product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.