Important Safety Instructions - Fluval PRISM 2.0 Bedienungsanleitung

IMPORTANT SAFETY INSTRUCTIONS

EN
WARNING – To guard against injury, basic safety precautions should be observed, including
the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
and all the important notices on the appliance before using. Failure to do so may result in loss of fish
life and/or damage to this appliance.
2. DANGER – To avoid possible electric shock, special care should be taken since water is employed
in the use of aquarium equipment. For each of the following situations, do not attempt repairs
yourself; return the appliance to an authorized service facility for service or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage, immediately unplug it from the
power source.
B. Carefully examine the appliance after installation. It should not be plugged in if there is water
on parts not intended to be wet. If the appliance or any part of it falls into the water DO NOT
reach for it. First unplug the unit before retrieving.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or it is
dropped or damaged in any manner. The power cord of this appliance cannot be replaced; if the
cord is damaged, the appliance should be discarded. Never cut the cord.
D. To avoid the possibility of the appliance plug or receptacle getting wet, position the appliance
to one side of a wall mounted receptacle to prevent water
from dripping onto the receptacle or plug. A "drip loop"
(see illustration) should be arranged by the user for the
cord connecting appliance to a receptacle. "The drip
loop" is that part of the cord below the level of the
receptacle or the connector if an extension cord is used,
to prevent water traveling along the cord and coming in
contact with the receptacle. If the plug or receptacle
does get wet, DO NOT unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the
appliance. Then unplug and examine for presence of water in receptacle.
3. This appliance is not intended for use by persons (including children) with significantly impaired
physical or mental capabilities, unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety. Children should always be
supervised to ensure that they do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5. CAUTION - Always unplug or disconnect all appliances in the aquarium from electricity supply
before placing hands in water, before putting on or taking off parts and while the equipment is
being installed, maintained or handled. Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect. Always unplug an appliance from an outlet when not in use.
6. Do not install or store the appliance where it will be exposed to weather or temperatures below
freezing. FOR INDOOR HOUSEHOLD USE ONLY.
7. Make sure the appliance is mounted correctly and securely positioned on the aquarium before
operating the appliance.
8. If an extension cord is necessary, a cord with proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the
cord so that it will not be tripped over or pulled. The connection should be carried out by a qualified
electrical installer.
9. The socket-outlet shall be installed near the equipment and shall be easily accessible.
10. LED power supply shall not be positioned on or into the cover frame.
11. "Z" attachments: The external flexible cable or cord of this luminaire cannot be replaced; if cord
is damaged the luminaire shall be destroyed.
12. ATTENTION: The light source of this luminaire is not replaceable; when the light source reaches
its end of life the whole luminaire shall be replaced.
13. ATTENTION: Do not stare at the operating light source.
SAVE THESE INSTRUCTIONS
For the complete use and understanding of this product it is recommended that this manual is
thoroughly read and understood. Failure to do so may result in damage to this product.
The Fluval Prism is a remote-controlled, high-output spotlight LED that allows the user to
create up to 80 multi-color lighting options, including special effects, to match any décor or
desired mood effect.
INSTALLATION AND USAGE:
Please verify that all components of the light fixture are undamaged before putting it into
operation. Before any kind of maintenance, always disconnect electrical supply of the light
fixture.
IMPORTANT: The Fluval Prism is designed to work only when fully submerged in water. Do
not operate dry.
• Affix light fixture to the inside glass of the aquarium.
(See illustration 1)
Note: Light fixture should be positioned so that
it will illuminate the tank and its inhabitants.
• Ensure there is a direct line-of-sight between the
fixture's sensor and the remote control. Press suction
cup firmly against the glass to ensure proper adhesion.
Note: Make sure the light fixture is mounted correctly
and securely positioned on the aquarium before
operating the appliance.
• Connect the plug to the electrical supply.
Illustration 1