Grape BTS-1000 Bedienungsanleitung Seite 4

will blink for seconds as the BTS-1000 is searching for the second
receiver. At this point, the audio on first connected receiver will be
disconnected temporally (also see note
3. The BTS-1000 will auto connect to the "pairing" devices. When
BTS-1000 and receiver are connected, the LED on BTS-1000 will
go to permanently lit.
Note:
1. In some case, the first paired device will not automatically be
reactivated. You need to power off and on the first paired device, and
press the pairing button on BTS-1000 for 1 second to wake the first
paired device.
2. BTS-1000 can connect two Bluetooth A2DP receivers at the same time,
In some cases, if you want to connect a new A2DP device, you need to
reset the BTS-1000 and reconnect all receivers.
Reset Method
Press the "pairing" key on BTS-1000 for 5 seconds and then release it.
The LED on BTS-1000 will start blinking and search for "pairing" A2DP
devices nearby.
Indication
Flash once 1 sec per 5
secs
Permanently lit
Indication of LED
Meaning
Power on /
Pairing
Connected
4
1).
Description
Searching the device under
pairing mode
Device and main unit are
connected