Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In case of allergic reaction after 48 h of use you
11.
should contact the dermatologist.
12.
To clean and maintain the device you should only
use damp soft cloth. You should clean and sterilize mills
regularly and change the bands after each use.
13.
Choose mills and bands accordingly to use. Using
too big or too sharp mill while cutting, cleaning or filing
nails or cuticles can cause skin irritation.
14.
You should only use standard accessories with this
device.
Directions of use
1.
Plug in the device to the power source.
Make sure that the power switch on the device is in
2.
„O" position, install the handle to the device base. Place
a fitting mill up to resistance. Selecting the mill should
be based according to the nailcare way you choose. You
can also adjust the band of selected thickness.
In order to start, put the power switch into „I"
3.
position, choose direction by choosing „I"/"II" on
direction switch, next turn the speed knob from MIN
position to the selected speed. You should also put
the power switch on the handle to "I" position. Device
base diode should turn to green when it's connected
successfully.
4.
During device operation you can change direction
and speed level anytime, by pressing direction switch
and turning speed knob.
5.
In order to finish operation, put power switch on
handle into "O" position, next put power switch on
device base into "O" position as well.
EN
3
Werbung
Inhaltsverzeichnis
