1. Please make sure all parts are accounted for before beginning assembly.
2. The handles (part 4) and bottle opener (part 6) are pre-installed on the cooler basin.
3. Place main basin up-side down on a clean soft surface. Attach each leg (parts 9) using
the M6x12 bolt screw (part 8). Tighten with a wrench into the main basin.
4. Place the supporting rack (parts 10) on the legs, then insert and tighten each wheel
(parts 11&12) into a leg.
5. Attach the bottle-cap catcher (parts 9) to the main basin by sliding it down over 2 pre-
installed bolts.
6. Attach 2 lid handles (parts 1) to the cooler lid by using 2 5/32" x 1/2" screw. Tighten
with a Philips screwdriver.
7. Clean the inside of the cooler completely with a soft dry towel. Place the cooler lid
(parts 2) on top of the main basin. Your cooler is now ready for use.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany
5