Werbung
User Manual
Introduction
Thank you for purchasing the LINDY IR over CAT5 Extender Kit. This simple to use plug and play
extender allows you to control up to 4 AV source devices* via IR remote control over distances of up to
450m, without direct line of sight. Perfect for use with concealed AV installations and in combination with
CAT5/Fibre AV extenders which do not offer IR extension. Using low cost CAT5/6/7 cabling the IR over
CAT5 Extender Kit sends IR signals to deliver full control of your AV equipment overcoming CEC
limitations or incompatibilities and for use with non-CEC equipped HDMI AV products.
The IR Receiver is small enough to be discreetly attached to a TV via its adhesive base, whilst the IR
Emitter features an adhesive front, allowing it to be positioned directly over an IR port. The IR Receiver
and Emitter can easily be extended using standard 3.5mm audio extension cables (LINDY No. 35460-5).
*1 x IR Emitter included, additional IR Emitters (LINDY No.38016) required to operate extra devices.
Package Contents
IR over CAT5 Extender
IR over CAT5 Receiver
IR Receiver, 1.4m x 1
IR Emitter, 1.4m x 1
5V 1.2A Multi-Country Power Supply - 5.5/2.5mm Outer/Inner
This manual
Specification
IR over CAT5 Extender
RJ45
IR Receiver Port 3.5mm
Power Supply Port
Installation
The following diagram shows a typical set up using 4 AV source devices*. Installation is simple, connect
the equipment as shown below and ensure that the IR Receiver is positioned so that it can easily
receiver IR signals. At the remote end, ensure that the IR Emitter(s) are positioned to that they can
broadcast to the IR Eye on your AV equipment.
Display
IR Receiver
CAT5/6/7 Cable
IR over CAT5
up to 450m
Extender
IR over CAT5 Receiver
RJ45
IR Emitter Port 3.5mm x 4
Supported IR Frequency: 20 – 60kHz
IR over CAT5
Receiver
English
IR Emitter
Up to 4 AV Sources eg.
BluRay, Satellite STB,
AV Receiver etc
Werbung
