Setup; Setup Location Requirements; Electrical Connection - ellrona 61494 Bedienungsanleitung

12.5 Setup

12.5.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup
location must fulfill the following prerequisites:
• The device must be positioned on a solid, even, horizontal and heat-resistant
base with sufficient load-supporting capacity for the appliance itself plus the
heaviest anticipated cooking contents.
• Keep the device and its cables away from open flames and hot surfaces.
• Select an installation location where children cannot reach the appliance's
hot surface.
• To operate correctly, the device requires a sufficient flow of air. Leave a 15
cm gap on all sides when setting up the appliance.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations
(e.g. on ships) must be carried out by specialist companies / electricians,
provided they guarantee the prerequisites for the safe use of this device.
• Do not use the device outside.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the
following instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and
frequency) on the rating plate with those of your electrical network. This data
must agree in order that no damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may employ a
3 meter long (max.) extension cable with a cross-section of 1.5 mm². The use
of multiple plugs or gangs is prohibited because of the danger of fire that is
involved with this.
• Make sure that the power cable is undamaged and has not been installed
under the oven or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the device is connected
to a properly installed protective conductor system. Operations using an
electrical outlet without a protective conductor are prohibited. If in doubt, have
the house installation checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by
a missing or damaged protective conductor.
ellrona Partypfanne 29